MTS 793 Controller Hardware FlexTest GT Controller Connections
145
How to connect
hydraulic terminals on
master-dependent 407
Controllers
The following figure shows how to cable hydraulic terminals on three
Model 407 Controllers in a master-dependent daisy-chain. Note that the
last dependent controller in any daisy-chain must have jumper plugs
installed in its Hyd Out and Intlk In terminals.
Sending and Receiving Signals to a Model 407 Controller
After cabling the Model 407 Controller, you must configure it to receive
and send signals from the FlexTest GT Controller. The tables below list
typical menu settings. Refer to the Model 407 Controller Product
Information Manual for more information.
Jumper Plug PN
049-635-901
Jumper Plug PN
049-635-901
Hyd
In
Hyd
Out
Intlk
In
Intlk
Out
Dependant 407 Controller
Hyd
In
Hyd
Out
Intlk
In
Intlk
Out
Last Dependant
407 Controller
Hyd
In
Hyd
Out
Intlk
In
Intlk
Out
Master 407 Controller
No Connection
No Connection
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
