MTS Systems FlexTest IIm User Manual

MTS 793 Controller Hardware
Installing the 493.02 Chassis (FlexTest SE)
Installation
50
Chassis Installation Options
The chassis can be fitted with the optional handle kit for table-top use
in the standalone configuration (shown below), and for the automated
configuration it can be installed without the handle-kit in a standard
MTS equipment rack.
Note For information about installing the optional handle kit, see page 56.
Model 493.40 I/O Carrier mezzanine cards
M
ODEL MODULE NAME FUNCTION
493.14 Valve Driver Produces the control signal for a Series 252 Servovalve.
493.15 3–Stage Valve Driver Produces the control signal for a Series 256 or 257
Servovalve.
493.25 Universal Conditioner Processes the signals from either an AC or DC-type sensors.
493.45 A/D Converts up to six external analog signals to digital signals for
use by the controller.
493.46 D/A Converts up to six internal digital signals to analog signals for
use by external devices.
493.47 Encoder Processes the signals from an encoder or a Temposonics III
transducer with an SSI interface.
FlexTest SE
Emergency Stop
7
8 9
65
4
3
2
1
.
0
+/-
enter
cancel
FG
Setup
Status
Scope
Meters
Tuning
Config
Limits
Log
Menu
?
A
B
Recall
Enabled
reset
Rewind Run
Hold Stop
Power
Program
Hydraulic
Interlock
Program
Interlock
HPU
HSM
Off
Low High
Off
Low High
Navigate
Monitor 1
Monitor 2
TS-G436
FlexTest SE
Emergency Stop
7
8 9
65
4
3
2
1
.
0
+/-
enter
cancel
FG
Setup
Status
Scope
Meters
Tuning
Config
Limits
Log
Menu
?
A
B
Recall
Enabled
reset
Rewind Run
Hold Stop
Power
Program
Hydraulic
Interlock
Program
Interlock
HPU
HSM
Off
Low High
Off
Low High
Navigate
Monitor 1
Monitor 2
TS-G436
FlexTest SE
Controller with
optional handle kit
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

MTS Systems FlexTest IIm Specifications

General

Brand	MTS Systems
Model	FlexTest IIm
Category	Controller
Language	English