MTS Systems FlexTest IIm User Manual

MTS 793 Controller Hardware
204
Adding I/O Carrier For automated controllers, a second I/O Carrier module can be added
to support a second channel or to expand sensor conditioning. Its
addition can also be used to support more A/D and D/A channels.
Note If you are upgrading your system, a faster processor may be
required. Contact MTS for information on system upgrade
requirements.
To add a second I/O Carrier module, complete the following:
1. Install the required mezzanine cards in the I/O Carrier module.
2. Install a second Model 493.40 I/O Carrier module in slot 3 of the
controller chassis.
3. Change your hwi file to reflect the added I/O Carrier module and
its mezzanine cards.
4. Use Station Builder to allocate resources for the additional
hardware.
Sensor Connections
See Sensor Connections 78.
See Sensor Cables 90.
See Shunt Calibration/Bridge Completion Resistor Installation 92.
See Transducer Identification Modules 95.
m
493.40
I/O
CARRIER
J3
S E
R
V
I
C
E
SHUNT CAL
1 2 3 4
J4 I/O J5 I/O J6 I/O J7 I/O
MVME
2100
493.42
SYSTEM
I/O
MOTOROLA
J28 HSM
J25 Hpu E-stop J29
J49 Aux Pwr
Intlk J43
J54 Dig In
Dig Out J55
J51 Box In
Box Out J52
Analog In
Analog out
TYPE E PC-MIP
TYPE E PC-MIP
RUN 6TS BFL
ABT RST
DEBUG
PCI MEZZANNE CARD
Power
100240 VAC
5060 Hz, 126A
AIR
FLOW
m
m
493.40
I/O
CARRIER
J3
S E
R
V
I
C
E
SHUNT CAL
1 2 3 4
J4 I/O J5 I/O J6 I/O J7 I/O
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

MTS Systems FlexTest IIm Specifications

General

Brand	MTS Systems
Model	FlexTest IIm
Category	Controller
Language	English