MTS 793 Controller Hardware FlexTest IIm Controller Connections
187
Cabling and Programming External Controllers
Cabled properly, you can use your FlexTest controller to send test
commands to another controller. For detailed setup information, see
“How to Program an External Controller” on page 187.
When programming Series 2200 and 2400 Eurotherm temperature
controllers, the FlexTest IIm controller supports a special serial
connection and software setup. For more information, see
“Programming Eurotherm Temperature Controllers” on page 191.
How to Program an External Controller
To send programming to an external controller, you must:
1. “Cable the controllers.” on page 187.
2. “Create your configuration file with Station Builder.” on page 190.
3. “Adjust the signals with Station Manager.” on page 190.
4. “Set up your program.” on page 191.
Task 1 Cable the controllers.
Standard Configuration For a standard configuration (using the 498.65 ADDA module), cable
the analog inputs and outputs between your FlexTest controller and
the external controller. Analog I/O connectors are located on the rear
of the test processor chassis.
1. Connect a 498 Analog Out connector to the external controller
program (analog) input.
2. If you will monitor sensor feedback for data acquisition or control
feedback, connect the external conditioner output to a 498 Input
Filter connector.
For conditioner output locations on various MTS devices, see
“Sample conditioner output connections” on page 190.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
