MTS Systems FlexTest IIm User Manual

MTS 793 Controller Hardware
FlexTest IIm Controller Connections
186
Remote Station Controller (RSC) Connections
When equipped with a GRES III plug-in module and a corresponding
498 RS-485 transition module, your FlexTest IIm controller can
accommodate up to four remote station controllers (one RSC for each
station).
Each RSC connects to a J50 serial connector on the 498 RS-485
transition module. The hwi file defines which connector is used for
each station.
hwi file additions In order to use one or more RSCs with your FlexTest controller, two
sections must be added to your hwi file, an RSC section and a GRES III
section.
Note If you specified RSC support when you ordered your test system,
these sections will be added to your hwi file at the factory.
Note For information on editing your hwi file to accommodate RSCs, refer
to the Hwi File Editor manual.
m
498
RS-485
TRANSITION
MODULE
+12V +5V
J50A
J50B
J50C
J50D
J7 SERIAL
4
98
RS
-4
8
5
T
rans
i
t
i
on
M
o
d
u
l
e
Cable the RSC to the proper J50 serial
connector (usually
J50A) using cable PN
055-634-3XX.
Off
Low
Interlock HSM Test Manual Control
Emergency Stop
F1 F2 F 3 F4 Status
Remote Station Control
Enable /
Disable*
Reset High
Hold
Stop
Run
Off
Low
High
HPS
055-634-3XX
Remote Station Controller
Use Jumper Plug 055-634-101
in these connectors.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

MTS Systems FlexTest IIm Specifications

General

Brand	MTS Systems
Model	FlexTest IIm
Category	Controller
Language	English