MTS 793 Controller Hardware
203
Sensor cables See “Sensor Cables” on page 90 for a detailed list of sensor cables and
part numbers.
For the most current part numbers, see the System Cable/Jumper Plug
493 Package Selection drawing (PN 700-000-656).
Model 493.40 I/O Carrier Connections
See Model 493.40 I/O Carrier Connections 77
Automated option Automated FlexTest SE Controllers are designed to be used with a PC,
MTS 793 software, and various types of support files, including a
hardware interface file (hwi) file. The hwi file defines each type of
electronic module in the chassis (and associated mezzanine cards), and
maps each module location for the MTS 793 software. The hwi file and
the physical locations for each type of module and associated
mezzanine cards must match. Also, the I/O Carrier module address
setting (on the module) must match the hwi file address.
Auxiliary Power (Aux Pwr) Per System 493.42 J48 N/A
Box In 056-316-0xx 493.42 J51 N/A
Box Out 056-316-0xx 493.42 J52 100-057-246
Digital Input (Dig In) Per System 493.42 J54 N/A
Digital Output (Dig Out) Per System 493.42 J55 N/A
Analog In (Anlg In) Per System 493.42 N/A
Analog Out (Anlg Out) Per System 493.42 N/A
* -XX specifies cable length. –01 through –09 represent 10–50 ft. in 5 ft. increments. Higher
numbers represent custom cable lengths
.
† Jumper plugs are required if a cable is not installed.
‡ The connector is the 10/100 BaseT connector on the power PC module.
Model 493.02 Chassis Cables (part 2 of 2)
C
ABLE DESCRIPTION PART
N
UMBER
*
MODULE
C
ONNECTOR
JUMPER
P
LUG
†
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
