Epson FX Emulation
241
Character Set
This parameter selects a character set for the Epson emulation, as
shown in the “Epson FX Character Set Menu” on page 242. Note
that when OCR-A or OCR-B is selected as the print language, the
Font Attribute Typeface option under the LinePrinter Plus menu
(page 212) is changed to OCR-A or OCR-B, respectively.
To use one of these sets, choose the desired group heading (such
as European Sets) and press ENTER. Then choose the desired set
within that group (such as Roman 8) and press ENTER. Both the
group and the desired set will be starred to indicate your selection.
Character sets are shown in detail in the
Character Sets Reference
Manual
.
20 CPI Condensed
Compressed print characters are narrower than the normal
character set. This is helpful for applications where you need to
print the maximum amount of information on a page.
• Enable (default). Prints about 60 percent of the width of normal
characters when compressed print is chosen by the host
computer. For example, a 12 CPI Draft font will compress to 20
CPI.
• Disable. Does not compress print widths, even if condensed
print is chosen by the host.
Alt. Set 80-9F
• Control Code (default). Interprets data in the range of hex 80
through hex 9F as a control code.
• Printable. Prints data in the range of hex 80 through hex 9F.
To Next Page
Loading...
Need help?
General