Saving Your New Configuration
59
Saving Your New Configuration
The Save Config. option allows you to save up to eight custom
configurations to meet different print job requirements. Once you
have changed all of the necessary parameters, you may save them
as a numbered configuration (Example 1 on page 60) or a named
configuration (Example 2 on page 63) that can be stored and
loaded later for future use. If you do not save your configuration
using the Auto Save, or this option, all of your parameter changes
will be erased when you power off the printer.
Once you have saved a custom configuration using this option, it
will not be lost if you power off the printer. You can load a
configuration for a specific print job (see “Load Config.” on
page 80). You can also modify and resave it. You may want to print
your configurations (see “Print Config.” on page 81) and store them
in a safe place, such as inside the printer cabinet. If the Protect
Configs. parameter is enabled and you try to resave an existing
configuration, the new configuration will not be saved until the
existing configuration has been deleted (see “Delete Config.” on
page 81).
NOTE: Once you change active emulations, any changes to the
previously selected emulation will be gone unless they
have been saved.
To Next Page
Loading...
Need help?
General