Oki MICROLINE MX Series User Manual

Chapter 6 Reprogramming The Security Key
306
Figure 25. Inserting The SPX into the Debug Port
4. Power on the printer. The printer will begin its boot-up sequence.
5. When the printer detects a valid SPX, the control panel displays:
“NEW SPX DETECTED
PRESS ENTER”
NOTE: If an error message displays, find the message in the Message
List in Chapter 7 and follow the troubleshooting instructions.
6. Press the ENTER key to activate the reprogramming sequence.
The display will read:
“PROGRAMMING. PLEASE WAIT.”
7. When the security key is reprogrammed, the display will read:
“REMOVE USED SPX
THEN PRESS ENTER”
8. Remove the SPX from the debug port at the rear of the printer.
A
A
Debug Port
SPX

Oki MICROLINE MX Series Specifications

General

Brand	Oki
Model	MICROLINE MX Series
Category	Printer
Language	English