Omron NX-EC0112 User Manual

4 Installation and Wiring
4 - 20
NX-series Position Interface Units User’s Manual (W524)
This section describes wiring for the following terminals:
• I/O power supply terminals
• I/O terminals
You can connect twisted wires, solid wires, or ferrules attached to twisted wires to the screwless clamp-
ing terminal block. The applicable wire dimensions and preparation methods are given below.
 Dimensions of Wires Connected to the Terminal Block
The wire dimensions that you can insert into the wire holes on the screwless clamping terminal block
are given in the following figure. Prepare wires with these dimensions that also meet the applicable
wire specifications given below.
 Using Ferrules
If you use ferrules, attach the twisted wires to them.
Observe the application instructions for your ferrules for the wire stripping length when attaching fer-
rules.
Precautions for Correct Use
Always use plated one-pin ferrules. Do not use unplated ferrules or two-pin ferrules.
Wiring Terminals
Applicable Wires
1.6 mm max. (except ground terminals)
2.0 mm max. (ground terminals)
2.4 mm max. (except ground terminals)
2.7 mm max. (ground terminals)

Omron NX-EC0112 Specifications

General

Brand	Omron
Model	NX-EC0112
Category	Controller
Language	English