Omron NX-SID Series User Manual

Additional Information
If you distribute multiple Safety Control Unit and set the device names and node addresses for
exporting.
• Saving the Safety Application Data
Place all of the Safety Control Unit
on one Slave Terminal and export the settings.
Use the Multiview Explorer to move NX Units between Slave Terminals.
Drag
• Reusing the Safety Application Data
Import the safety control file.
Move the Safety Control Unit
from the Slave Terminal where you imported the file to the other
Slave Terminals.
from the Slave Terminal where you imported the file to the other Slave Terminals.
5-9-2
Exporting/Importing the Settings for All the NX Units on a CPU
Rack or Slave Terminal
Y
ou can export the operating settings and the application data (including safety application data) for all
of the NX Units, except for the NX bus master, in the CPU Rack settings or the Slave T
erminal settings
into a single file (extension .nsfp).
1 Display the CPU Rack or Slave Terminal Tab Page where the Safety CPU Unit to export is con-
figured.
2 Right-click the CPU Unit or the Communications Coupler Unit and select Export All NX Unit
Settings from the menu.
The Export All NX Unit Settings Dialog Box is displayed.
5 System Configuration and Setup
5 - 41
NX-series Safety Control Unit User's Manual (Z930)
5-9 Exporting/Importing Settings Data
5
5-9-2 Exporting/Importing the Settings for All the NX Units on a CPU Rack or Slave Terminal

Omron NX-SID Series Specifications

General

Brand	Omron
Model	NX-SID Series
Category	Controller
Language	English