Protrusion for removing the Unit
Protrusion for removing the Unit
Precautions for Correct Use
• To remove an NX Unit, remove multiple NX Units together including the one you need to re-
move. If you attempt to remove only one NX Unit, it may be tight and difficult to pull out.
•
Do not unlock the DIN Track mounting hooks on all of the NX Units at the same time. If you
release the DIN Track mounting hooks on all of the NX Units at the same time, all of the NX
Units will come off.
3-1-4
Installation Orientation
Installation Orientation in the Case of a CPU Unit
Orientation is possible only in the upright installation orientation.
However, there are restrictions on the specifications depending on the NX Units to be used.
Refer to the user's manuals for the NX Units and System Units that you will use for details on restric-
tions.
Installation Orientation on Slave Terminals
The Slave Terminal can be installed in any of the following six orientations.
3 Installation and Wiring
3 - 6
NX-series Safety Control Unit User's Manual (Z930)
To Next Page
Loading...
Need help?
General
