Omron NX-SID Series User Manual

l
Temperature Input Units
The table below shows the NX Unit models that support communications between the NX Units as
well as the combinations of the Unit version and Sysmac Studio version.
Model Unit version Sysmac Studio
NX-TS2101 Ver. 1.0 Ver. 1.22 or higher
Ver. 1.1 Ver. 1.22 or higher
NX-TS2102 Ver. 1.1 Ver. 1.22 or higher
NX-TS2104 Ver. 1.1 Ver. 1.22 or higher
NX-TS2201 Ver. 1.0 Ver. 1.22 or higher
Ver. 1.1 Ver. 1.22 or higher
NX-TS2202 Ver. 1.1 Ver. 1.22 or higher
NX-TS2204 Ver. 1.1 Ver. 1.22 or higher
NX-TS3101 Ver. 1.0 Ver. 1.22 or higher
Ver. 1.1 Ver. 1.22 or higher
NX-TS3102 Ver. 1.1 Ver. 1.22 or higher
NX-TS3104 Ver. 1.1 Ver. 1.22 or higher
NX-TS3201 Ver. 1.0 Ver. 1.22 or higher
Ver. 1.1 Ver. 1.22 or higher
NX-TS3202 Ver. 1.1 Ver. 1.22 or higher
NX-TS3204 Ver. 1.1 Ver. 1.22 or higher
The data types in the following table are supported for communications between NX Units.
Data Type
BOOL
BYTE
INT
WORD
DINT
A-17-2
Functions That Were Added or Changed for Each Version
This section gives the Safety Control Unit-related functions that were added or changed for each ver-
sion.
Description
Change or
addition
Corresponding unit version/
version
Reference
Sysmac Stu-
dio
Safety CPU
Unit
NX-SL££££
Supported model added.
• NX-SL3500
Addition Ver.1.08 or
higher
Ver. 1.0 or later 2-1 Safety CPU Unit on page
2 - 2
Offline debugging Addition 6-8 Offline Debugging on page
6 - 79
Appendices
A - 109
NX-series Safety Control Unit User's Manual (Z930)
A-17 Version Information
A
A-17-2 Functions That Were Added or Changed for Each Version

Omron NX-SID Series Specifications

General

Brand	Omron
Model	NX-SID Series
Category	Controller
Language	English