Omron NX-SID800 User Manual

6 System Configuration and Setup
6 - 32
NX-series Safety Control Unit User’s Manual (Z930)
Additional Information
If you distribute multiple Safety Control Units on different EtherCAT Slave Terminals, you can
use the following method to manage all of the safety control settings in one file.
• Saving the Safety Application Data
Place all of the Safety Control Units on one Slave Terminal and export the settings.
Use the Multiview Explorer to move NX Units between Slave Terminals.
• Reusing the Safety Application Data
Import the safety control file.
Move the Safety Control Units from the Slave Terminal where you imported the file to the
other Slave Terminals.
You can change the locations of Units on the Multiview Explorer with Sysmac Studio version
1.10 or higher.
You can export the operating settings and the application data (including safety application data) for all
of the NX Units, except for the Communications Coupler Unit, in the Slave Terminal settings into a sin-
gle file (extension .nsfp).
1 Display the Slave Terminal Tab Page where the Safety CPU Unit to export is configured.
6-9-2 Exporting/Importing the Settings for All the NX Units on a Slave
Terminal
Drag

Omron NX-SID800 Specifications

General

Brand	Omron
Model	NX-SID800
Category	Controller
Language	English