Omron NX-SID800 User Manual

9 - 7
9 Troubleshooting
NX-series Safety Control Unit User’s Manual (Z930)
9-3 Checking for Errors with the Sysmac Studio
9
9-3-1 Checking for Errors from the Sysmac Studio
9-3 Checking for Errors with the Sysmac
Studio
Error management on the NX Series is based on the methods used for the NJ/NX-series Controllers.
This allows you to use the Sysmac Studio to check the meanings of errors and troubleshooting proce-
dures.
When an error occurs, you can place the Sysmac Studio online to the Controller or the EtherCAT Cou-
pler Unit to check current Controller errors and the log of past Controller errors.
Refer to the user’s manual for the connected Communications Coupler Unit for information on checking
errors.
Open the Sysmac Studio’s Controller Error Tab Page to check the current error’s level, source, source
details, event name, event codes, details, attached information 1 to 4, and correction.
Errors in the observation level are not displayed.
Additional Information
Number of Current Errors
The following table gives the number of errors that are reported simultaneously as current
errors in each Unit.
If the number of errors exceeds the maximum number of reportable current errors, errors are
reported with a priority given to the oldest and highest-level errors. The errors that occur
beyond this limit are not reported.
Errors that are not reported are still shown in the error status.
9-3-1 Checking for Errors from the Sysmac Studio
Current Errors
Unit Number of simultaneous errors
Safety CPU Unit 32
Safety I/O Unit 16

Omron NX-SID800 Specifications

General

Brand	Omron
Model	NX-SID800
Category	Controller
Language	English