ZFX-C
16
ZFX-C User’s Manual
Part Names and Functions
Cameras
Cameras with lighting
Camera only (C-mount type)
Name. Description
(1) Optional lighting connector This connector is used to connect an optional lighting. (ZFX-SC50_/SC90_)
When no optional lighting is used, make sure that the connector is covered with the
cap. If not, water-resistant performance will be deteriorated.
(2) Ventilation film This film prevents the front panel from condensation.
• Do not peel off or probe the ventilation film with a sharp-pointed object. If you do
that the protective structure rating may no longer be satisfied.
• Do not cover the ventilation film rating. Doing so might cause the front panel to be
condensed.
(3) Focus adjustment control This control is used for adjusting the focus of the image.
(4) Mounting fixture This mounting fixture is used for fastening the camera when installing it. The mount-
ing fixture can be installed on all of the four mounting surfaces.
(5) Lighting connector This connector is used to connect external lighting (Strobe Controller: 3Z4S-LT
MLEK-C100E1TSX). Note, however, that the Strobe Controller cannot be connected
when the right angle camera cable is used.
(6) Camera cable connector
This connector is used for connecting to the Controller via a camera cable (ZFX-VS__/VSR__).
(7) Camera mounting base
This camera mounting base is fastened with screws to hold the camera in place. The camera
mounting base can be installed on all of the four mounting surfaces.
To Next Page
Loading...
Need help?
General
