To Next Page

To Previous Page

5.2.4.5 Wireless XDP Parallel Mode

Description

A PS can be used in parallel with a wired telephone (PT/SLT). In this case, the wired telephone is the main

telephone and the PS is the sub telephone. When Wireless XDP Parallel Mode is enabled, the two telephones

share one extension number (main telephone’s extension number).

Cell Station

PBX

Wireless XDP

Parallel Mode

PT/SLT

Extn. 103

Conditions

• If one of the telephones goes off-hook while the other telephone is on a call, the call is switched to the

telephone going off-hook. However, the call is not switched in one of the following conditions:

a. During a Conference call (® 2.14 Conference Features).

b. While Live Call Screening (LCS) or Two-way Record is activated (® 3.2.2.19 Live Call Screening

(LCS) and 3.2.2.34 Two-way Record/Two-way Transfer).

c. While receiving OHCA (DPT over a stacking connection only) (® 2.10.4.3 Off-hook Call

Announcement (OHCA)).

d. While being monitored by another extension (® 2.10.3 Call Monitor).

e. During Consultation Hold.

f. During a Conference Group Call (® 2.15.1 Conference Group Call).

• Wireless XDP Parallel Mode can only be set from a PS. The wired telephone can accept or deny this feature

through COS programming. Once this feature is set, the setting at the wired telephone cannot be changed

unless a PS changes the setting.

• The following features are not available for extensions in Wireless XDP Parallel Mode while the PS is on

a call (however, they are available for extensions in Wireless XDP Parallel Mode while the wired telephone

is on a call):

– Executive Busy Override (® 2.10.2 Executive Busy Override)

– Whisper OHCA (® 2.10.4.4 Whisper OHCA)

– CCBS (® 4.1.2.10 Completion of Calls to Busy Subscriber (CCBS))

• If a SIP extension is paired as either the wired extension (e.g., KX-UT series SIP phone) or the wireless

extension (e.g., S-PS), both telephones ring when an incoming call arrives. However, no other functions,

such as switching the call between telephones, are available.

• If an incoming call arrives while the PS is on a call, the wired extension will indicate an incoming call but

will not ring. However, if the wired telephone is a SIP extension, the telephone will ring.

• Most of the extension data (e.g., extension number, extension name) of the wired telephone is used for its

PS as well. However, the PS has its own extension data for the following:

Feature Guide 461

5.2.4 Portable Station (PS) Features

Panasonic KX-NS1000 User Manual

Other manuals for Panasonic KX-NS1000