4.8
Cleanfire Fuel Injection
Instrument Cluster Fuel Selector
The fuel selector feature is built into the instrument cluster
on all 2013 PRO-RIDE models.
When using <91 octane, oxygenated, or when unsure of
the
fuel type inside the fuel tank, set gauge to “ETH”
mode.
When using 91+ non-oxygenated fuels, set gauge to
“91--NON mode”.
Analog/Digital Instrument Cluster:
1. Start the engine.
2. Lock the parking brake.
3. Press and release the MODE button on the left
ha
ndlebar control until either “ETH” or “91--NON” is
displayed on the instrument cluster.
4. Press and hold the MODE button on the left handlebar
con
trol to change between fuel settings.
Digital Instrume
nt Cluster:
1. Start the engine.
2. Lock the parking brake.
3. Press and release the “SEL” button on the gauge or
the
“SET” button on the left hand control until either
“Eth” or “91--non” is displayed in the lower section of
the instrument cluster.
4. Press and hold the “SEL” button on the gauge or the
“SET”
button on the left hand control until the desired
fuel type is displayed on the screen.
Always verify ETHANOL is selected on the instrument
cluster if unsure of fuel type. Severe engine damage
may occur if PREMIUM mode is selected when using
ethanol-blended fuel.
Never use fuels containing more than a 10% ethanol
blend.
To Next Page
Loading...
Need help?
General
