9.2
Chassis
SAFETY INFORMATION
General Cautions and Notes
• Never re-use lock Nuts. Always replace lock nuts
that have been removed with new parts.
• Never re-use pre-coated fasteners. Always
re
place pre-coated fasteners with new parts.
• The side braces, bulkhead floor, and the front
tu
nnel cooler upper mating surface are bonded
components.
• The only authorized bonding adhesive is Lord 406
A
crylic Adhesive. DO NOT ANY NON-SPECIFIED
BONDING ADHESIVE, GLUE, OR EPOXY.
• Lord 406 Acrylic Adhesive has a shelf life of no
mor
e than 60 days at 68° F (20° C) from the time
of manufacture. Do not store this product. Order
repair kit as required and dispose product after
repair is completed in accordance with local rules
and regulations.
• Wear gloves, face mask, and protective eye wear
wh
en removing original adhesive from chassis
components.
• Never apply excessive heat or flame to bonded
co
mponents when not intending to remove them
from the chassis.
• The engine overstructure/steering support
asse
mbly and floor board support tubes are
bonded components. THESE COMPONENTS
ARE NOT SERVICEABLE. REPLACE AS
COMPLETE ASSEMBLIES.
• Bonded components must be removed, cleaned,
and
re-bonded if the adhesive is subjected to
temperatures above 300° F (149° C).
• Adhesive working time is 6 to 10 minutes.
Co
mponent handling time is achieved within 60
minutes. Complete cure time will take 24 hours at
68° F (20° C).
• Allow the adhesive to cure at room temperature
68°
F (20° C). Do not move the snowmobile
outside (colder temperature) while the adhesive is
curing.
• Do not place the vehicle into service until the
adh
esive has completely cured (24 hours).
Lord 406 Acrylic Adhesive Information
Review and understand the following product handling
practices and first aid measures prior to working with
bonding adhesive.
For additional handling, first aid, or MSDS information,
co
ntact Lord at www.lord.com.
Lord 406 Acrylic Adhesive is flammable. Do not store or
use near heat, sparks, or open flame.
Handling Practices
Ventilation - Work in a well-ventilated area.
Respirator - Use properly-fitted, organic vapor, air
purifying respirator (face mask).
Skin Protection - Use neoprene, or rubber gloves. Wash
hands and exposed skin with soap and water after
working with product.
Eye Protection - Wear safety glasses/goggles.
First Aid Measures
Eye Contact - Flush eyes immediately with large
amounts of water for at least 15 minutes holding eyelids
open while flushing. Get prompt medical attention.
Skin Contact - Flush contaminated skin with large
amounts of water while removing contaminated
clothing. Wash affected skin areas with soap and water.
Get medical attention if symptoms occur.
Inhalation - Move person to fresh air. Restore and
support continued breathing. If breathing is difficult, give
oxygen. Get immediate medical attention.
Ingestion - If swallowed, do not induce vomiting. Give
victim one or two glasses of water or milk. Call a
physician or poison control center immediately for
further instructions. Never give anything by mouth if
victim is rapidly losing consciousness, unconscious, or
convulsing.
To Next Page
Loading...
Need help?
General
