Chapter 9: Configuration
Scheduler
Quantum DXi6900 User’s Guide 279
Use the PhysicalDeviceDiscovery page to perform the following tasks:
l To discover an attached physical tape library and tape drives, click Scan. Attached physical libraries
display in the list.
l To enable or disable a physical library, select it in the list, and then click Enable or Disable. (You can
also right-click a library to enable or disable it.)
l To use a physical library, it must be enabled. If you enable or disable a library, all tape drives in the
library are also enabled or disabled.
l To view the drives in an attached library, select the library in the list. All drives in the selected library
display below.
l To enable or disable tape drives, select one or more drives in the list, and then click Enable or
Disable. (You can also right-click a drive to enable or disable it.)
Note:To use a tape drive, it must be enabled. To enable a drive, the parent library must be
enabled.
l To remove a physical library from the list, first disconnect the Fibre Channel cables that connect the
library to the DXi6900, and then click Scan.
l To update the libraries or drives list with the latest information, click Refresh.
Scheduler
The Scheduler page allows you to manage scheduled events on the DXi6900, including replication and
replication throttling, e-mail reports, healthchecks, and space reclamation. With schedules, you specify
when certain events should occur, and the system automatically performs those events at the specified time.
Events can be one-time only, or they can reoccur at defined intervals.
To access the Scheduler page, click the Configuration menu, and then click the Scheduler tab (see
Figure 173 on the next page).
To Next Page
Loading...
Need help?
General