RADWAG MA 3Y User Manual

- 135 -
27. COMMUNICATION PROTOCOL
General information
A. A character based communication protocol moisture analyzer-terminal is
designed for establishing communication between a RADWAG instruments
and a peripheral devices via RS 232 interface.
B. It consists of commands sent from a peripheral device to a moisture
analyzer and responses from the moisture analyzer.
C. Responses are sent from the moisture analyzer on each receipt of a
command as a reaction for a specific command.
D. Commands forming the communication protocol enable obtaining data on
moisture analyzer’s status and influencing its operation, e.g.: request
measurement results from a moisture analyzer, zero indication, etc.
27.1. A set of commands
Command Command description
Z
Zero moisture analyzer
T Tare moisture analyzer
OT Give tare value
UT Set tare
S Send stable measurement result in basic measuring unit
SI
Immediately send measurement result in basic measuring
unit
SU
Send stable measurement result in current measuring unit
SUI
Immediately send measurement result in current
measuring unit
C1
Switch on continuous transmission in basic measuring unit
C0 Switch off continuous transmission in basic measuring unit
CU1
Switch on continuous transmission in current measuring
unit
CU0
Switch off continuous transmission in current measuring
unit
DH Set low checkweighing threshold LO
UH Set high checkweighing threshold HI
ODH Give value of low checkweighing threshold LO
OUH
Give value of high checkweighing threshold HI
PC Send all implemented commands
LOGIN User log in
LOGOUT User log out
SS Result release
IC
Internal calibration

RADWAG MA 3Y Specifications

General

Brand	RADWAG
Model	MA 3Y
Category	Measuring Instruments
Language	English