Terminal connected to mains, battery charged, no connection of the terminal with the
weighing module.
Settings
For ensuring long enough operation while powering the device by means of
battery, the correct parameters of group OTHER must be set, <Sleep mode>
<Display brightness>. For more information refer to point 33 of this manual
titled Other Parameters.
5. STARTUP
• On plugging the power cord to moisture analyzer’s power plug, switch on
the moisture analyzer using the main switch located next to the power
plug at the back of instrument’s housing.
• On switching on, instrument’s diode ON/LOAD located
on terminal’s housing is lit up.
• Press powering key located on the upper right section of
terminal’s overlay. Within a few seconds, the RADWAG OS starts loading,
which is signaled by flickering red diode ON/LOAD.
• On completing the startup procedure, the instrument’s displays main
window of the software.
• The moisture analyzer starts up with no user logged in. In order to start
operation, a user has to log in. (logging procedure is described further in
this user manual).
To Next Page
Loading...
Need help?
General
