4.5. Cleaning
Remember to unplug the moisture analyzer from mains before any
cleaning activities.
Clean the moisture analyzer using a damp cloth by gentle rubbing
contaminated places.
Remember to remove the drying pan from the drying chamber before
its cleaning. Cleaning the drying pan assembly while installed may
damage instrument’s measuring system, thus remove it from the cross-
shaped holder.
4.6. Plugging to mains
A moisture analyzer can be plugged to mains only by means of
original power cord, which comes standard with the moisture
analyzer. Rated voltage (specified on device’s data plate) must be
compatible with mains rated voltage.
The power cord can be connected only to a socket with ground contact. Plug
the power cord to the moisture analyzer. The moisture analyzer’s power plug
is located at the back of its housing.
4.7. Connecting peripheral equipment
The moisture analyzer must be unplugged from the mains before connecting
or disconnecting any peripheral equipment (printer, PC computer). Use only
peripheral equipment recommended by the manufacturer with your moisture
analyzer. These have been ideally coordinated to your moisture analyzer. On
connecting a peripheral device, plug the moisture analyzer to mains.
4.8. Interfaces
Description of terminal’s interfaces
To Next Page
Loading...
Need help?
General
