Caution: If more than one reference tare value is programmed (with
corresponding minimum sample mass) then the indicated value automatically
moves to a range corresponding to the weight of the tarred container. At the
same time the required minimum mass is changed.
11.8. Cooperation with titrators
In order to ensure correct cooperation with TITRATORS it is necessary to set
<Mass for titrator> option to <YES> value. The setting must be done for
standard printout content. Any other variables for this printout must be off.
If the option is on, the user shall notice an icon informing about specific mass
printout format accepted by TITRATORS. The icon is located in the top toolbar of
the main window.
To Next Page
Loading...
Need help?
General
