10.2. Return to weighing mode
Changes introduced in moisture analyzer’s memory are automatically (and
permanently) saved on returning to displaying the main window.
Procedure:
- Press key for a few times, until the software returns to displaying
the main window.
- press soft key in the upper bar on the display. The software
immediately returns to displaying the main window
11. WEIGHING
Load a weighed object on the weighing pan. On stabilization of weighing
result, indicated by stability marker visible on the left side of the terminal’s
display, read the measurement result.
Saving / printout of the measurement result is available on pressing <PRINT>
key.
Depending on software settings, either stable or unstable measurement result
can be printed, if printed measurement result in unstable (stability pictogram
is not displayed), then it is accompanied by question mark <?> in front of
printed mass value.
11.1. Selection of measuring unit
Change of measuring unit is carried out by pressing the measuring unit
pictogram visible next to the value of measurement result on the display.
Pressing the measuring unit pictogram opens a list with available units. On
selecting one of them, the software automatically recalculates the indicated
mass value to the active measuring unit.
Available measuring units:
To Next Page
Loading...
Need help?
General
