PG-FP5 APPENDIX A MESSAGES
R20UT0008EJ0400 Rev. 4.00 Page 211 of 240
Jul 15, 2010
(3/3)
No. Message Description
I 2416 The selection is out of range. The VDD2 value exceeds the range defined in the PR5 file.
I 2417 The selection is out of range. The selected value is out of the valid range.
I 2418 Input data is out of range. The selected clock value exceeds the range defined in the
PR5 file.
I 2419 Caution: Boot Block swapping will not be possible with this
selection. Anyhow, boot block protection is possible.
Boot swapping is not available because the selected block
number is larger than half the total block numbers defined
in the PR5 file. Boot block protection can be enabled.
I 2420 Illegal OCD security ID setting. The value in the [OCD Security ID Setting] box is illegal.
I 2421 Illegal option byte setting. The value in the [Option bytes setting] box is illegal.
I 2500 Welcome to FP5 Manager!
[Yes]:Continue to set FP5 Manager
[No]:Return to Standard mode unsecured
−
I 2501 Initialize as shipment condition?
Warning: After initialization all data and parameter settings
in FP5 will be deleted.
−
I 2601 Buffer is modified. Are you sure to close? The HEX Editor temporary file has been changed. This
change is lost when the HEX Editor is closed.
I 2602 This file is not valid. The file selected by the HEX Editor is invalid.
I 2603 End record not found, created. The end record is missing. The HEX editor will add the HEX
format end record ':00000001FF' to the file.
I 2604 Save?
Select whether to save the data. Click 'Ok' to save the data.
Click 'Cancel' to not save the data.
I 2605 The file is modified. Are you sure to quit?
The file has been modified. Select whether to abort the
operation. Click 'Yes' to abort without saving changes. Click
'No' to continue the operation.
I 2606 The file is modified. Save file? The file has been modified. Select whether to save
changes.
To Next Page
Loading...
Need help?
General
