RL78/F13, F14 CHAPTER 1 OVERVIEW
R01UH0368EJ0210 Rev.2.10 9
Dec 10, 2015
Table 1-6. RL78/F13 (LIN incorporated) Functions List (2/2)
Series Name R5F10AM R5F10AL R5F10AG R5F10AB R5F10AA R5F10A6
Pin Count 80 pins 64 pins 48 pins 32 pins 30 pins 20 pins
TAU Products with at least 96 Kbytes of code
flash memory
16 bits (8ch + 4ch) 
Products with up to 64 Kbytes of code flash
memory
16 bits
(8ch + 4ch)
16 bits (8ch)
Timer RTC 1ch
Timer RJ 16 bits ï‚´ 1
Note 1
Timer RD 16 bits ï‚´ 2
Serial I/F CSI/simplified
I
2
C /UART
Products with at least
96 Kbytes of code flash
memory
4ch/4ch/2ch 
Products with up to 64
Kbytes of code flash
memory
4ch/4ch/2ch 2ch/2ch/1ch
SPI Yes
Multimaster I
2
C Products with at least
96 Kbytes of code flash
memory
1ch 
Products with up to 64
Kbytes of code flash
memory
1ch None
LIN/UART module (RLIN3) 1ch
CAN interface (RS-CAN lite) None
A/D converter
10-bit SAR
VDD Products with at least
96 Kbytes of code flash
memory
16ch 16ch 13ch 
Products with up to 64
Kbytes of code flash
memory
16ch 12ch 12ch 8ch 10ch 4ch
EVDD Products with at least
96 Kbytes of code flash
memory
4ch 3ch 2ch 
Products with up to 64
Kbytes of code flash
memory
4ch None
Internal 2ch
D/A converter 8-bit None
Comparator None
ELC None
PCLBUZ 1ch None
Self-programming Yes
On-chip debug Trace Yes
Hot plug-in Yes
Option byte Yes
Notes 1. The 20-pin products do not have TRJIO0 and TRJO0 pins.
2. The following pairs of internal and external sources are each counted as a single source in this number:
INTP4 and INTSPM.
3. The following pairs of internal and external sources are each counted as a single source in this number:
INTP4 and INTSPM, INTP6 and INTTM11H, INTP7 and INTTM13H, INTP8 and INTRTC, INTP9 and
INTTM01H.
4. The following pairs of internal and external sources are each counted as a single source in this number:
INTP4 and INTSPM, INTP6 and INTTM11H, INTP7 and INTTM13H, INTP8 and INTRTC, INTP9 and
INTTM01H, INTP10 and INTTM03H.
5. NTP11 and INTLIN0WUP are counted as a single source because using them at the same time is not
possible.
6. Do not use the XT1 and XT2 pin functions in grade-Y products.
Caution For details, see 1.5 Pin Configurations.