RL78/F13, F14 CHAPTER 31 ON-CHIP DEBUG FUNCTION
R01UH0368EJ0210 Rev.2.10 1653
Dec 10, 2015
Notes 1. Address differs depending on products as follows.
Products (code flash memory capacity) Address of Note 1
R5F10AxA (x = 6, A, B, G) 03FFFH
R5F10AxC (x = 6, A, B, G, L) 07FFFH
R5F10AxD (x = 6, A, B, G, L) 0BFFFH
R5F10AxE (x = 6, A, B, G, L, M) 0FFFFH
R5F10AxF (x = G, L, M) 17FFFH
R5F10AxG (x = G, L, M) 1FFFFH
R5F10BxC (x = A, B, G, L) 07FFFH
R5F10BxD (x = A, B, G, L) 0BFFFH
R5F10BxE (x = A, B, G, L, M) 0FFFFH
R5F10BxF (x = A, B, G, L, M) 17FFFH
R5F10BxG (x = A, B, G, L, M) 1FFFFH
R5F10PxD (x = A, B, G) 0BFFFH
R5F10PxE (x = A, B, G, L, M, P) 0FFFFH
R5F10PxF (x = G, L, M, P) 17FFFH
R5F10PxG (x = G, L, M, P) 1FFFFH
R5F10PxH (x = G, L, M, P) 2FFFFH
R5F10PxJ (x = G, L, M, P) 3FFFFH
2. When real-time RAM monitor (RRM) function and dynamic memory modification (DMM) function are not
used, it is 256 bytes.
3. In debugging, reset vector is rewritten to address allocated to a monitor program.
4. Since this area is allocated just under the stack area, the address of this area varies depending on the stack
increase and decrease. That is, 4 extra bytes are consumed for the stack area used.
When using self-programming, 12 extra bytes are consumed for the stack area used.
To Next Page
Loading...
Need help?
General
