RL78/F13, F14 CHAPTER 32 BCD CORRECTION CIRCUIT
R01UH0368EJ0210 Rev.2.10 1654
Dec 10, 2015
CHAPTER 32 BCD CORRECTION CIRCUIT
32.1 BCD Correction Circuit Function
The result of addition/subtraction of the BCD (binary-coded decimal) code and BCD code can be obtained as BCD code
with this circuit.
The decimal correction operation result is obtained by performing addition/subtraction having the A register as the
operand and then adding/ subtracting the BCD correction result register (BCDADJ).
32.2 Registers Used by BCD Correction Circuit
The BCD correction circuit uses the following registers.
ï‚· BCD correction result register (BCDADJ)
(1) BCD correction result register (BCDADJ)
The BCDADJ register stores correction values for obtaining the add/subtract result as BCD code through
add/subtract instructions using the A register as the operand.
The value read from the BCDADJ register varies depending on the value of the A register when it is read and those
of the CY and AC flags.
The BCDADJ register is read by an 8-bit memory manipulation instruction.
Reset input sets this register to undefined.
Figure 32-1. Format of BCD Correction Result Register (BCDADJ)
Address: F00FEH After reset: undefined R
Symbol 7 6 5 4 3 2 1 0
BCDADJ
To Next Page
Loading...
Need help?
General
