Rigol DS4024E User Manual

RIGOL Chapter 6 Operations and Measurements
6-6 DS4000E User’s Guide
2. Specify the FFT source
Press Source, turn the multi-function knob to select the desired channel
and press the knob. You can also press Source continuously to switch the
channel currently selected. The channels available are CH1, CH2, CH3 and CH4.
3. Adjust the vertical position and vertical scale
Press
and respectively; turn the multi-function knob to adjust the
vertical scale and vertical position of the FFT operation waveform. Please refer
to “MATH Waveform Vertical Control”.
4. Adjust the horizontal scale and horizontal position
Use HORIZONTAL
SCALE and HORIZONTAL POSITION to adjust
the horizontal scale and horizontal position of the FFT operation waveform
respectively. For the adjustment methods, please refer to “
To Adjust the
Horizontal Time Base” and “To Adjust the Horizontal Position”.
5. Specify the window function
Spectral leakage can be considerably decreased when a window function is used.
DS4000E provides four kinds of FFT window functions (as shown in Table 6-1
)
which have different characteristics and are applicable to measure different
waveforms. You need to select the window function according to the
characteristics of the waveform to be measured.
Press Window, turn the multi-function knob to select the desired window
function and press the knob. You can also press Window continuously to switch
the window function currently selected. The default is “Rectangle”.

Rigol DS4024E Specifications

General

Brand	Rigol
Model	DS4024E
Category	Test Equipment
Language	English