Siemens SIMOTICS S-1FL6 User Manual

Basic operator panel (BOP)
6.5 Auxiliary functions
SINAMICS V90, SIMOTICS S-1FL6
204 Operating Instructions, 04/2019, A5E36037884-007
Note
Plugging or unplugging the micro SD card/SD card will cause transferring failure.
Do not plug or
unplug the micro SD card/SD card during transferring; otherwise, the
transferring operation will fail.
Note
Parameter inconsistency
If the parameters on the micro SD card/SD card are inconsistent with existing parameters in
the drive memory, you must
restart the servo drive to apply the changes.
6.5.6
Updating firmware
With the firmware update function of the BOP, you can update the drive firmware. To do this,
you have to store proper firmware files on a micro SD card/SD card and insert it into the
micro SD card/SD card slot. After that, proceed as follows.
After you have updated the firmware, you need to set parameters to their default values.
Refer to "Setting parameters to default (Page 202)" about the default process.
Note
Before updating the firmware, you can back up the drive data on a micro SD card/SD card. If
you want to use them after the update, you can
copy the data from the micro SD card/SD
card to the drive
(Page 203).

Siemens SIMOTICS S-1FL6 Specifications

General

Brand	Siemens
Model	SIMOTICS S-1FL6
Category	Servo Drives
Language	English