Safety Integrated function
8.1 Standards and regulations
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
301
Risks must be reduced by designing and implementing the machine accordingly (e.g. by
means of controllers or protective measures suitable for the safety-related functions).
If the protective measures involve the use of interlocking or control functions, these must be
designed according to EN ISO 13849-1. For electrical and electronic controllers, EN 62061
can be used as an alternative to EN ISO 13849-1. Electronic controllers and bus systems
must also comply with IEC/EN 61508.
Risk reduction measures for a machine can be implemented by means of safety-related
control functions in addition to structural measures. To implement these control functions,
special requirements must be taken into account, graded according to the magnitude of the
risk. These are described in EN ISO 13849-1 or, in the case of electrical controllers
(particularly programmable electronics), in EN 61508 or EN 62061. The requirements
regarding safety-related controller components are graded according to the magnitude of the
risk and the level to which the risk needs to be reduced.
defines a risk flow chart that instead of categories results in hierarchically
graduated Performance Levels (PL).
uses "Safety Integrity Level" (SIL) for classification purposes. This is a
quantified measure of the safety-related performance of a controller. The required SIL is also
determined in accordance with the risk assessment principle according to ISO 12100 (EN
To Next Page
Loading...
Need help?
General
