7.2 Additional software for HMI
Note
Action before installing additional software
Before installing additional software, make sure that you terminate the runtime of the
SIMOTION P.
You terminate SIMOTION P in the application SIMOTION P State using the button Terminate
SIMOTION P.
If required, the following software can be installed directly on the SIMOTION P320‑4:
● WinCC flexible Runtime
● WinCC flexible engineering system for P320-4 S
● OPC client from other manufacturers
● Utilities of the OEMs
● SIMATIC NET
This software must be purchased separately and is not contained in the SIMOTION P320‑4
scope of delivery.
Please refer to the documentation supplied with the software for details regarding the
procedure for installing the respective software.
7.3 Customer-specific software
To ensure high-quality and reliable working of the device, SIMOTION P320-4 is fully configured
and ready for operation at the time of delivery.
For this purpose, the system components used are subject to a certification procedure with
Siemens as the system manufacturer. The certification process establishes and documents
the real-time features of the complete system.
NOTICE
Changes or expansions of PC components (hardware or software) by a third party
If PC components (hardware or software) are modified or expanded by a third party,
compliance with product features cannot be guaranteed. The OEM or user involved must
assume sole responsibility for such components.
Compliance with product features can only be guaranteed by SIEMENS.
Power on and software installation
7.3 Customer-specific software
SIMOTION P320-4 E / P320-4 S
118 Commissioning and Hardware Installation Manual, 11/2016
To Next Page
Loading...
Need help?
General
