Siemens SINAMICS G120 User Manual

Vector control
Function diagrams
2-589
© Siemens AG 2011 All Rights Reserved SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Fig. 2-80 6491 – Flux control configuration
- 6491 -
Function diagram
87654321
FP_6491_97_51.vsd
Vector control
G120 CU230P-2
13.12.2010 V4.4
Flux control configuration
01
02
00
[6722.5]
[6722.3]
[6723.7]1
0
03
04
05
06 0
07
08
09
10
11
12
13
14
15
Flux control, configuration
Bit No. Meaning
Factory setting
1 = Flux setpoint, soft starting active
1 = Flux setpoint, differentiation active
1 = Quick magnetization
Reserved
Reserved
Reserved
1 = Flux build-up control active
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Flux ctrl config
- ... -
p1401 [D] (0000 0110 bin)
[6723.6]

Siemens SINAMICS G120 Specifications

General

Power Range	0.37 kW to 250 kW
Output Voltage	0 V to Input Voltage
Frequency Range	0 Hz to 650 Hz
Enclosure Rating	IP20, IP21, IP55
Control Modes	V/f control, vector control, servo control
Protection Features	Overvoltage, undervoltage, short circuit
Communication Interfaces	PROFIBUS, PROFINET, Modbus RTU
Operating Temperature	-10°C to +50°C
Cooling Method	Air cooling
Input Voltage	200 V to 240 V, 380 V to 480 V, 500 V to 690 V