Cycles
9.4 Zyklenunterstützung im Programmeditor
Cylindrical grinding
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
161
9.4 Zyklenunterstützung im Programmeditor
The program editor provides programming support for adding cycle calls to the program and
for entering parameters.
Function
The cycle support offers the following functions:
● Cycle selection via soft keys
● Input screen forms for parameter assignment with help displays
Decompilable program code is generated from the individual screens.
Summary of required files
The following files constitute the basis for cycle support:
● sc.com
● cov.com
Note
These files are loaded during the start-up of the control system and must always remain
loaded.
To Next Page
Loading...
Need help?
General
