Data Backup
12.3 Reading in / reading out PLC projects
Cylindrical grinding
356 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
12.3 Reading in / reading out PLC projects
When reading in a project, this will be transferred to the file system of the PLC and then
activated. To complete the activation, the control system is restarted (warm start).
Reading in project from CompactFlash card/USB FlashDrive
To read in a PLC project, perform the following operator actions:
1. CompactFlash card/USB FlashDrive are inserted
2. Press the "Customer CF card"/"USB drive" softkey and select the line with the desired
project file in PTE format.
3. Press "Copy" to copy the file to the clipboard.
4. Press the "802D data" softkey and position the cursor on the PLC Project (PT802D
*.PTE) line.
5. Press the "Paste" softkey; reading in and activation starts.
Writing project to CompactFlash card/USB FlashDrive
Perform the following operator actions:
1. CompactFlash card/USB FlashDrive are inserted
2. Select the "802D data" softkey and position the direction keys on the PLC project
(PT802D *.PTE) line.
3. Press "Copy" to copy the file to the clipboard.
4. Press the "Customer CF card"/"USB drive" softkey and select the saving location for the
file.
5. Press the "Paste" softkey; the writing process starts.
To Next Page
Loading...
Need help?
General
