Siemens SINUMERIK 802D User Manual

Data Backup
12.4 Copying and pasting files
Cylindrical grinding
Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
357
12.4 Copying and pasting files
In the <PROGRAM MANAGER> operating area and in the "Start-up files" function, files or
directories can be copied into another directory or onto a different drive using the softkey
functions "Copy" and "Paste". When doing so, the "Copy" function enters the references to
the files or directories in a list which is subsequently executed by the "Paste" function. This
function will perform the actual copying process.
The list is kept until a new copying process overwrites this list.
Special situation:
If the RS232 interface has been selected as the data target, "Paste" will be replaced by the
"Send" softkey function.. When reading in files ("Receive" softkey), it is not necessary to
specify a target, since the name of the target directory is not contained in the data flow.

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English