Item name Description Range or choices (under line: Ini-
tial value)
Mode Used to display the right to access the MIB information. READ_ONLY
Trap Settings
This function makes the settings for trap notification to the SNMP manage. Click [Apply] to immediately apply the
settings.
Item name Description Range or choices (under line: Ini-
tial value)
Enable/Disable Used to enable or disable the SNMP Trap function. Enable
Disable
Name Used to set the SNMP community name. Up to 64 ASCII code characters
public
Network Interface Used to display the corresponding network interface. XKS-C81XX 1st: LAN1/1
XKS-C81XX 2nd: LAN2/1
XKS-C91XX 1st: LAN1-1/1
XKS-C91XX 2nd: LAN2-1/1
Destination IP Ad-
dress
Used to enter the trap destination address. 0.0.0.0 to 255.255.255.255
Destination Port Used to enter the port number of the trap destination address. 0 to 162 to 65535
Version Used to select the SNMP version. V1
V2C
Test Trap
Clicking [Send] notifies the test trap for system verification according to the trap settings.
MIB data
Clicking [Retrieve] opens another tab of the web browser to display the MIB information.
1-14-7. NMOS Function Settings
This section describes settings for NMOS of the IP Video Interface (ST2110) board.
Use the [NMOS] tab of the web menu to make the settings.
Note
To make the NMOS function available, the board firmware version must be 1.40 or later.
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
1-34
To Next Page
Loading...
Need help?
General
