Steris AMSCO 7053HP User Manual

5 — Cycle and Control Value Programming
113
10432589_G AMSCO® 7000 Series
Operator Manual
4. Enable (Yes) or disable (No) printer.
5. Enable (Yes) or disable (No) extended cycle printout feature.
NOTE: The extended printout offers more information about the cycle phases and data.
6. If printer was enabled in Step 4, press PRINT to Print All Cycles. This will produce a printout of all programmed
cycle parameters, one after the other.
7. If printer was enabled in Step 4, press PRINT to Print Supervisor Settings.
8. Once settings are completed, press Close on touch screen until reaching desired screen.
5.11 Date and Time Menus
To set current date and/or time, access Date screen or Time screen as follows:
NOTE: Daylight saving is not automatic and has to be changed manually.
1. Access Supervisor mode as explained in Section 5.2, Supervisor Mode Menus. Display shows Supervisor mode
screen:
2. Press Right arrow on touch screen until accessing following supervisor mode menus:
3. Press Set Date or Set Time on Supervisor mode screen. Display shows corresponding screen.
4. Follow instructions on touch screen to set current date or time.
5. Once settings are completed, press Close on touch screen to return to Supervisor mode screen.

Steris AMSCO 7053HP Specifications

General

Brand	Steris
Model	AMSCO 7053HP
Category	Washer
Language	English