6 — Routine Maintenance
157
10432589_G AMSCO® 7000 Series
Operator Manual
1. Holes
2. Door
3. Detection Bar
9. When first door safety switch is verified, display automatically shows message requesting activation of second
door safety switch. Repeat Step 8 with left hole of detection bar.
10. When second door safety switch is verified, display automatically shows message requesting to close load door.
Press Close Door to close load door. Load door closes.
11. Repeat Step 6 to Step 10 to verify both door safety switches on bottom of unload door.
NOTE: Once test is completed, the 750-cycle reminder is reset to 0. Door safety reminder will be displayed again
in 750 cycles.
6.14 Sump Safety Level Test
IMPORTANT: Supervisor password is required to perform this procedure.
Every 979 cycles, a sump safety test is required to verify water level in washer/disinfector sump. While
washer/disinfector is in Ready mode, an audible signal sounds and a message is displayed to remind the supervisor
that the safety level test must be performed. If the supervisor decides to bypass he safety level test, the message pops
up again after 25 cycles. The message will be displayed every five cycles until the safety level test is performed.
1. Display shows sump safety level test due reminder.
2. Press Ack to acknowledge test reminder.
3. Display requests supervisor password entry.
4. Enter Supervisor mode password using available touch pads on keyboard screen.
To Next Page
Loading...
Need help?
General
