Suzuki LT-A400 Service Manual

Fuel System: 1G-14
Installation
Install the fuel valve in the reverse order of removal. Pay
attention to the following points:
WARNING
!
Replace the gasket washers (1) and gasket
(2) with new ones to prevent fuel leakage.
• Tighten the fuel valve bolts to the specified torque.
Tightening torque
Fuel valve bolt: 4.6 N·m (0.46 kgf-m, 3.5 lb-ft)
Fuel Filter Inspection and Cleaning
B827H11706020
Inspect and clean the fuel filter in the following
procedures:
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation (Page 1G-13)”.
2) Remove the fuel valve. Refer to “Fuel Valve
Removal and Installation (Page 1G-13)”.
3) Check the fuel filter for sediment or rust.
If the fuel filter is dirty with sediment or rust, fuel will
not flow smoothly and loss in engine power may
result. Clean the fuel filter with compressed air.
4) Reinstall the fuel valve. Refer to “Fuel Valve
Removal and Installation (Page 1G-13)”.
5) Reinstall the fuel tank. Refer to “Fuel Tank Removal
and Installation (Page 1G-13)”.
Fuel Level Gauge Removal and Installation
B827H11706021
Removal
WARNING
!
Gasoline is very explosive. Extreme care
must be taken.
1) Remove the fuel tank upper cover. Refer to “Fuel
Tank Removal and Installation (Page 1G-13)”.
2) Remove the fuel level gauge cap (1).
3) Remove the fuel level gauge (2).
Installation
Install the fuel level gauge in the reverse order of
removal. Pay attention to the following points:
• When installing the fuel level gauge, “1/2” indication
must be faced to forward.
1
2
I827H1170022-02
I827H1170023-01
1
I827H1170024-01
2
I827H1170026-01
I827H1170025-01

Suzuki LT-A400 Specifications

General

Brand	Suzuki
Model	LT-A400
Category	Offroad Vehicle
Language	English