Suzuki LT-A400 Service Manual

2B-3 Front Suspension:
Front Suspension Inspection
B827H12206004
Refer to “Suspension Inspection in Section 0B
(Page 0B-19)”.
Front Shock Absorber Inspection
B827H12206005
Inspect the front shock absorber for damage and oil
leakage, and absorber bushing for wear or damage. If
any defects are found, replace the front shock absorber
with a new one. Refer to “Front Shock Absorber
Removal and Installation (Page 2B-3)”.
CAUTION
!
Do not attempt to disassemble the front
shock absorber. It is unserviceable.
Front Shock Absorber Removal and Installation
B827H12206003
CAUTION
!
Make sure that the vehicle is supported
securely.
Removal
1) Place the vehicle on level ground.
2) Support the vehicle with a jack or wooden block.
3) Remove the front shock absorber (1).
Installation
Install the front shock absorber in the reverse order of
removal. Pay attention to the following point:
• Tighten the front shock absorber mounting bolt and
nut to the specified torque.
Tightening torque
Front shock absorber mounting bolt (upper) (a):
55 N·m (5.5 kgf-m, 40.0 lb-ft)
Front shock absorber mounting nut (lower) (b):
60 N·m (6.0 kgf-m, 43.5 lb-ft)
Front Wheel Hub / Steering Knuckle Removal
and Installation
B827H12206007
Removal
1) Remove the cotter pin (1) and loosen the hub nut (2).
2) Remove the front wheel. Refer to “Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-3)”.
3) Remove the brake caliper. Refer to “Front Brake
Caliper Removal and Installation in Section 4B
(Page 4B-3)”.
4) Remove the front wheel hub (3) by removing hub nut
(4) and washer (5).
I827H1220002-01
1
I827H1220003-01
(b)
(a)
I827H1220004-02
1
2
I827H1220005-01
3
4
5
I827H1220037-02

Suzuki LT-A400 Specifications

General

Brand	Suzuki
Model	LT-A400
Category	Offroad Vehicle
Language	English