Automatic Transmission: 5A-18
• Install the dowel pins and new gasket (3).
CAUTION
!
Use new gasket to prevent oil leakage.
• Install the drive V-belt inner cover.
CAUTION
!
Fit the gasket washer to the bolt “B”
• Install the drive/driven face assemblies and V-belt
outlet cover. Refer to “V-belt Type Continuously
Variable Automatic Transmission Removal and
Installation (Page 5A-7)”.
V-belt Outer Cover Bearing Removal and
Installation
B827H15106021
Removal
1) Remove the V-belt outer cover. Refer to “V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation (Page 5A-7)”.
2) Remove the oil seal (1).
3) Remove the snap ring (2).
Special tool
: 09900–06108 (Snap ring pliers)
4) Remove the bearing with the special tool.
Special tool
(A): 09921–20240 (Bearing remover set)
3
I827H1510059-01
“B”
I827H1510060-02
1
I827H1510061-01
2
I827H1510062-02
(A)
I827H1510063-01
To Next Page
Loading...
Need help?
General
