Starting System: 1I-16
Reel
Inspect the reel for wear or damage. If any defects are
found, replace the reel with a new one.
Rope
Inspect the rope for damage. If any defects are found,
replace the rope with a new one.
Specifications
Service Data (LT-A400/F, LT-F400/F)
B827H11907001
Unit: mm (in)
Tightening Torque Specifications
B827H11907002
NOTE
The specified tightening torque is also described in the following.
“Starter Motor Components (Page 1I-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in
Section 0C (Page 0C-9)”.
Special Tools and Equipment
Recommended Service Material
B827H11908001
I831G1190062-02
I831G1190063-01
Item Specification Note
Starter motor brush length
Standard 10 (0.39)
Limit 6.5 (0.26)
Starter relay resistance 3 – 5 Ω
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Starter motor mounting bolt 10 1.0 7.0 )(Page 1I-4)
Starter motor lead wire mounting nut 7 0.7 5.0 )(Page 1I-4)
Starter motor housing bolt 3.5 0.35 2.5 )(Page 1I-4)
Starter clutch bolt 26 2.6 19.0 )(Page 1I-10)
Recoil starter mounting bolt 10 1.0 7.0 )(Page 1I-13)
Recoil starter center nut 12 1.2 8.5 )(Page 1I-15)
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 1I-3) / )(Page 1I-4)
/ )(Page 1I-14) /
)(Page 1I-15)
Moly paste SUZUKI Moly paste or equivalent P/No.: 99000–25140 )(Page 1I-4)
Thread lock cement THREAD LOCK CEMENT SUPER
1322 or equivalent
P/No.: 99000–32110 )(Page 1I-13)
To Next Page
Loading...
Need help?
General
