Differential: 3B-28
• Apply gear oil to the oil seal lip.
• Install new oil seal by tapping it with a plastic mallet.
• Apply silicone grease to the O-ring.
: Grease 99000–25100 (SUZUKI SILICONE
GREASE or equivalent)
• Insert the final gear coupling (5) into the final gear
case.
• Hold the final gear coupling with the special tool and
tighten the nut to the specified torque.
Special tool
(C): 09924–64510 (Final driving gear
coupling holder)
Tightening torque
Final gear coupling nut (b): 100 N·m (10.0 kgf-m,
72.5 lb-ft)
• Lock the final gear coupling nut with a center punch.
Final Gear Related Parts Inspection
B827H13206018
Refer to “Final Gear Assembly Removal and Installation
(Page 3B-21)” and “Final Gear Assembly Disassembly
and Assembly (Page 3B-23)”.
Rear Drive Shaft
Inspect the splines of rear drive shaft for wear or
damage. Also, inspect the boots and spring for damage.
If any defects are found, replace the port with a new one.
I827H1320099-02
5
I827H1320097-02
(C)
(b)
I827H1320100-01
I827H1320101-01
I827H1320106-01
To Next Page
Loading...
Need help?
General
