3A-7 Drive Chain / Drive Train / Drive Shaft:
Rear Axle Construction
B827H13106009
Rear Axle / Axle Housing Removal and
Installation
B827H13106010
Removal
1) Remove the final gear case under cover. Refer to
“Final Gear Oil Replacement in Section 0B
(Page 0B-11)”.
2) Remove the rear wheel(-s). Refer to “Front / Rear
Wheel Removal and Installation in Section 2D
(Page 2D-3)”.
3) Remove the rear brake for right axle/housing
removal. Refer to “Rear Brake Disassembly and
Assembly in Section 4C (Page 4C-3)”.
4) Remove the rear wheel hub (1) for left axle/housing
removal.
(a)
1
(b)
2
(b)
2
(c)
3
(c)
3
(c)
4
(c)
4
(d)
5
(d)
5
(c)
6
(e)
7
(c)
6
(e)
7
(f)
8
I827H1310009-01
1. Swingarm pivot nut 8. Brake panel bolt : Apply grease.
2. Rear shock absorber nut (Upper) : 102 N⋅m (10.2 kgf-m, 74.0 lb-ft) : Apply silicon grease.
3. Rear shock absorber nut (Lower) : 35 N⋅m (3.5 kgf-m, 25.5 lb-ft) : Apply thread lock to thread part.
4. Rear axle housing mounting bolt (Swingarm) : 60 N⋅m (6.0 kgf-m, 43.5 lb-ft) : Apply thread lock to thread part.
5. Rear axle housing mounting bolt (Final gear
case)
: 55 N⋅m (5.5 kgf-m, 40 lb-ft) : Apply thread lock to thread part.
6. Rear wheel set nut : 121 N⋅m (12.1 kgf-m, 87.5 lb-ft)
7. Rear hub nut : 23 N⋅m (2.3 kgf-m, 16.5 lb-ft)
1
I827H1310026-01
To Next Page
Loading...
Need help?
General
