3A-5 Drive Chain / Drive Train / Drive Shaft:
8) Install a circlip (2) into the groove of front drive shaft
spline.
CAUTION
!
The removed circlip must be replaced with a
new one.
9) Inspect the axle play by using a push-and-pull
motion given to the axle shaft and wheel spindle.
Front Drive Shaft Inspection (LT-A400F, LT-
F400F)
B827H13106004
Inspect the front drive shaft in the following procedures:
1) Remove the front drive shaft assembly. Refer to
“Front Drive Shaft Assembly Removal and
Installation (LT-A400F, LT-F400F) (Page 3A-2)”.
2) Inspect the boots, circlip and boot bands for wear or
damage. If any damages are found, replace them
with new ones.
3) Install the front drive shaft assembly. Refer to “Front
Drive Shaft Assembly Removal and Installation (LT-
A400F, LT-F400F) (Page 3A-2)”.
2
I827H1310003-01
I827H1310004-01
I827H1310005-01
To Next Page
Loading...
Need help?
General
