Clean the condenser
If the system does not operate correctly, clean the
air-conditioning condenser in the cab-roof. To get
access to the condenser do the steps that follow:
Loosen the fastener and lift the latch (1).
Open the condenser cover (2).
Use the rod (3) to hold the cover open.
Remove all the unwanted material from the
surface of the condenser with a brush.
Close the condenser cover and tighten the
fastener.
GUID-0DF97B7D-4E92-4B02-BDB5-6269680A73E8-low.png [Low]
Fig. 1
If the fault continues, speak to your dealer and have a full inspection of the system.
4.1.4 Electrical service and maintenance
IMPORTANT:
Obey the correct procedure when you disconnect
and connect the electrical systems. If you do not,
you can cause damage to the machine.
WARNING: Flammable gas.
Heat or sparks can ignite gas from the
battery without warning. Explosion of
the battery or burns to personnel can
occur.
Do not put heat sources near to the
vehicle battery. Make sure that there
is good airflow through the work area
when you do work near batteries.
Always disconnect the cut-o switch or the battery
ground before you do work on the electrical
system.
Dierent battery manufacturers can have dierent
configurations of battery connections. Carefully
identify the configuration of the battery in your
machine.
GUID-7A015FFB-D345-435C-BB0D-5D0DC1A13153-high.jpg [High]
Fig. 2
4.1.4.1 Remove the battery
Before starting the procedure
WARNING: Flammable gas.
Heat or sparks can ignite gas from the battery without warning. Explosion of the battery
or burns to personnel can occur.
Do not put heat sources near to the vehicle battery. Make sure that there is good airflow
through the work area when you do work near batteries.
GUID-080A6DA9-B29D-4C10-B9BE-E8590C342B92 [V1]
GUID-8255A029-7479-4194-8954-9394A674EFC1 [V1]
4. Maintenance
144 F Series
39940211 (555124)