3.2.7 Select the speed of the PTO - independent mode to ground speed mode
DANGER: The machine has many mechanical parts that move.
The parts that move can hit persons.
Do not go in the dangerous areas of the machine during operation. The operator of the
machine must make sure that no person goes in the dangerous areas during operation.
With the PTO mode control lever (Independent or
Ground Speed) (1), you can go from a neutral
position (N) to independent mode (D), or ground
speed mode (E).
To select the ground speed mode, stop the
machine, and move the PTO mode control lever (1)
to the position (E).
GUID-AB37B67D-2268-479E-AD9F-79CD7057D949-high.jpg [High]
Fig. 96
When you engage the ground speed mode, the
GND indicator will show on the dashboard.
GUID-3C3DE44B-FBBE-4322-BD8E-23204FA9FB5F-high.jpg [High]
Fig. 97
NOTE:
In ground speed mode, the mechanical PTO clutch lever (2) has no eect.
NOTE:
The neutral position is not available on a machine with an electro-hydraulic transmission. Use the PTO
mode control lever (1) to select independent mode (D) or ground speed mode (E).
3.2.8 Operation of the PTO with the machine stopped
WARNING: The machine can move without warning.
The machine is heavy and can cause death or injury.
Park the machine on a clean, hard and level area. Set the parking brake to ON and install
the wheel chocks.
GUID-084DB7DD-4A00-47BF-87E1-BB2BEAD7C923 [V1]
GUID-56BC5723-DE72-4F2C-959C-FF9B0B997EF7 [V1]
3. Operation
100 F Series
39940211 (555124)
To Next Page
Loading...
Need help?
General
