11. Check the hydraulic oil level.
12. Check for leaks.
4.12.22 Replace transmission/hydraulic oil filter cartridge (third pump)
Before starting the procedure
CAUTION:
Before working on hydraulic oil filters, ensure that the hydraulic oil is cold. Wear
impervious protective gloves. Risk of burns, injuries and/or health problems.
Procedure
1. Disconnect the Battery.
2. Arrange a suitable container to collect the
hydraulic oil.
3. Disconnect the oil pipe (E).
4. Unscrew the filter cap (F).
5. Remove the filter cartridge (G).
6. Properly clean the filter cap (F) and its seat.
7. Apply a film of oil on the gasket.
GUID-5EA00CE4-62DC-4D57-A450-47E6C106920B-low.png [Low]
Fig. 120
8. Install new filter cartridge (G).
9. Refit the filter cap (F) and tighten at 70 Nm.
10. Reconnect the oil pipe (E).
11. Restore the transmission oil level with proper
oil.
12. Reconnect the Battery - Run the engine for
several seconds.
13. Check the hydraulic oil level.
14. Check for leaks.
GUID-338590BF-A358-4D4A-9B09-82DE1FA4FCD6-low.png [Low]
Fig. 121
GUID-AE7DA1E1-C0F3-4BBC-904A-18E4BAB29DA2 [V1]
4. Maintenance
F Series 205
39940211 (555124)
To Next Page
Loading...
Need help?
General
